1045 / C45 / S45C

1045 steel is a medium-carbon steel offering a good combination of strength, toughness, and machinability. It can be heat treated to improve its mechanical properties and surface hardened by induction or flame hardening, making it suitable for shafts, gears, and general engineering components.
Available Form
Round Bar
Custom Diameter & Length
Flat Bar
Custom Thickness, Width & Length
Square Bar
Custom Width & Length
Steel Plate
Custom Thickness, Width & Length
Steel Grade Comparison
W-Nr EN AISI JIS
1.0503 C45 1045 S45C
Chemical Composition(wt%)
C Si Mn P S Fe
0.43~0.50 0.15~0.40 0.60~0.90 ≤0.04 ≤0.05 Balance
Physical Properties

Density:7.86 g/cm³
Modulus of Elasticity: 200 GPa
Thermal Conductivity: 52.0 W/(m.K)

Temperature 20-100°C 2-200°C 2-300°C 2-400°C
Coefficient of Thermal Expansion (×10-6 /K) 12.5 13.0 13.6 14.1
Heat Treatment Process

Hardening: Heat the steel evenly to 820–850°C until the whole section reaches temperature. Then quench in water or oil.Annealing: Heat the steel evenly to 800–850°C, hold until uniform, then cool slowly inside the furnace.
Tempering: Heat the steel uniformly to 550–660°C, hold, and cool in still air. Hardness: 20–30 HRC.

Application Fields
Crankshafts, connecting rods, axles, and clutch components, drive shafts, transmission shafts, gears, and pinions, spindles, bolts, studs, and mechanical parts, piston rods and cylinder components, hammers, axles, and general-purpose engineering tools etc
Disclaimer: the information and data presented herein are typical values for reference and are not intended as warranties to readers.
REQUEST A QUOTE
Fill out this field
Please enter a valid email address.
Fill out this field
Fill out this field
Related Products